CS610 Quiz 1 Solution
Question # 1
CBR stands for…………….
Constant Bit Rate
Question # 2
The routing table in
interior and exterior switches has which one of the following?
(a) It should have next
hop for each possible destination
(b) The next hop in table
must be on shortest path to destination
(c) Both (a) and (b)
(d) None of the above
Question # 3
Which one of the
following is a method for computing routing table information?
Static routing
Question # 4
Which one of the
following is the responsibility of Djikstra’ algorithm?
(a) To compute the
shortest path between two nodes
(b) To extract next hop
information from path information
(c) To insert next hop
information into routing table
(d) All of the above
Question # 5
Routing table is used
to keep the information about…………….
Destination
Question # 6
Frame relay is………………….
Connection
oriented service
Question # 7
Which of the following
is not a guided medium?
Atmosphere
Question # 8
Which of the following
statement is wrong regarding PVC?
Forwarding table entries for PVC’s are dynamically configured.
Question # 9
Which of the following
statement is true regarding ATM?
(a) ATM is a single
technology that is designed to meet the goals of both LANs and WANs.
(b) ATM uses the concept
of connection-oriented networking.
(c) Both (a) and (b)
(d) None of the above
Question # 10
Djikstra’s algorithm
is used to compute the……………….
shortest path between two nodes
Question # 11
The sharing of a among the workers in an office is a good of resources sharing.
Printer
Question # 12
Thick ethernet also requires to avoid signal reflectance.
Terminators
Question # 13
The field of ethernet frame has the purpose of frame payload.
Data
Question # 14
In technique all members of network can send data only on the specific time slot?
TDMA
Question # 15
In Star Topology all computers are attched to a central hub.
Question # 16
IEEE 802.11 is standard wireless LAN that uses radui signals at 2.4GHz.
Question # 17
In Bus Topology terminators are used at the end of the cable
Question # 18
A network uses Ring Topology to arrange computers in a single closed loop.
Question # 19
Lan interface uses DMA to copy frame data directly from main memory.
Question # 20
In direct point to point communication adding the Nth computer requires N-1 new connections.
Question # 21
In CSMA technique all members of the network can send data only on the specific slot
Question # 22
FDDI uses counter rotating rings in which data flows in opposite directions
Question # 23
We need pockets rather than bits because sender and receiver need to coordinate to detect transmission errors.
Question # 24
The gigabit ethernet hardware operates at a rate of 1000 Mbps
Question # 25
Each computer in Lan is identitified by a physical address usually imprinted on the network interface card
Question # 26
Ethernet network does not depend on CSMA/CD.
Question # 27
The sharing of a amoung the workers in an office is a goal of resource sharing.
Question # 28
LAN interface hardware obeys CSMA/CD access rule.